Find a fuse

Ford Fiesta · 2016

2016 Ford Fiesta OBD Port Fuse

Code reader won’t power up? Check the fuse for the OBD diagnostic socket (Ford calls it the data link connector).

  • UK specification
  • Verified data
  • Checked 14 October 2026
  • Sources

Quick answer

Verified

Applies toBuilt from 12 January 2015Built from 17 August 2015Built 7 December 2015 to 7 May 2016Built from 9 May 2016

Fuse
19
Amperage
15A
Fuse box
Passenger compartment
Location
Behind the glove box

Where is the fuse box?

Passenger compartment fuse box

Behind the glove box

  1. Open the glove box and empty it.
  2. Press the sides of the glove box inwards and lower the glove box to reach the fuse box.

Fuse box diagram

Full 2016 Ford Fiesta fuse chart

We haven’t drawn a schematic of the passenger compartment fuse box for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.

Where to look

  • 19

    Behind the glove box

    Fuse ·15A · Data link connector

    Position not shown on the schematic. Find fuse 19 on the fuse box legend.

Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • Ignition on

    Most scanners need the ignition on to talk to the car, even if they light up without it.

  • Scanner compatibility

    Some basic scanners can’t communicate with every car. Try another scanner before assuming a fault.

  • Bent pins

    Check the socket under the dashboard for bent or pushed-back pins.

Sources & verification

Applies toBuilt from 12 January 2015

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toBuilt from 17 August 2015

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toBuilt 7 December 2015 to 7 May 2016

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toBuilt from 9 May 2016

Status
Verified
Specification
UK market
Last checked
14 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.