Quick answer

Verified

Applies toHandbook edition July 2018Handbook edition January 2019

Vauxhall’s handbook doesn’t print fuse ratings, so none is shown. Fit a replacement with the same rating as the fuse you remove — the handbook says: “Data on the replacement fuse must match the data on the defective fuse.”

Fuse
19
Fuse box
Engine compartment (mini fuses)
Location
The fuse box is in the engine compartment.

Where is the fuse box?

Engine compartment fuse box (mini fuses)

The fuse box is in the engine compartment.

  1. Disengage the cover, lift it upwards and remove.

Finding the fuse by number

Full 2019 Vauxhall Mokka fuse chart

Find it by number

Vauxhall’s handbook picture doesn’t give enough positional detail for us to draw a trustworthy map of the engine compartment fuse box (mini fuses), so we don’t draw one — we never guess where a fuse sits.

Use the numbers printed on the fuse box, inside its cover or on the fuse box picture in your owner’s manual, and find fuse 19. Check the number before removing anything.

Where to look

  • 19

    The fuse box is in the engine compartment.

    Fuse · Fuel pump

    Look for fuse number 19 on the fuse box or its cover — we don’t show positions without verified layout data.

Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • Fuel cut-off switch

    Many cars cut the fuel pump after a jolt or impact. Your handbook will show if there is a reset switch.

  • Listen for the pump

    Turn the ignition on and listen for a short hum from under the rear seat. Silence suggests a power or pump fault.

  • Fuel level

    A faulty fuel gauge can hide an empty tank. Add a few litres before going further.

  • Fault codes

    An OBD scanner can show stored codes for fuel pressure or pump circuit faults.

Sources & verification

Applies toHandbook edition July 2018

Status
Verified
Specification
UK market
Last checked
15 October 2026

Applies toHandbook edition January 2019

Status
Verified
Specification
UK market
Last checked
15 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.