Quick answer

Verified

Applies toHandbook edition July 2018Handbook edition January 2019

Vauxhall’s handbook doesn’t print fuse ratings, so none is shown. Fit a replacement with the same rating as the fuse you remove — the handbook says: “Data on the replacement fuse must match the data on the defective fuse.”

Fuse
36
Fuse box
Engine compartment (mini fuses)
Location
The fuse box is in the engine compartment.

Where is the fuse box?

Engine compartment fuse box (mini fuses)

The fuse box is in the engine compartment.

  1. Disengage the cover, lift it upwards and remove.

Finding the fuse by number

Full 2019 Vauxhall Mokka fuse chart

Find it by number

Vauxhall’s handbook picture doesn’t give enough positional detail for us to draw a trustworthy map of the engine compartment fuse box (mini fuses), so we don’t draw one — we never guess where a fuse sits.

Use the numbers printed on the fuse box, inside its cover or on the fuse box picture in your owner’s manual, and find fuse 36. Check the number before removing anything.

Where to look

  • 36

    The fuse box is in the engine compartment.

    Fuse · Front fog light

    Look for fuse number 36 on the fuse box or its cover — we don’t show positions without verified layout data.

Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • Headlights must be on

    Front fog lights usually only work with the sidelights or dipped beam switched on.

  • Bulbs

    If only one fog light is out, a blown bulb is far more likely than the fuse.

  • Water in the lamp

    Fog lights sit low and can let water in. Corrosion in the lamp or its connector can stop them working.

Sources & verification

Applies toHandbook edition July 2018

Status
Verified
Specification
UK market
Last checked
15 October 2026

Applies toHandbook edition January 2019

Status
Verified
Specification
UK market
Last checked
15 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.