Quick answer

Verified

Applies toHandbook edition July 2013Handbook edition January 2014Handbook edition August 2014

Vauxhall’s handbook doesn’t print fuse ratings, so none is shown. Fit a replacement with the same rating as the fuse you remove — the handbook says: “Data on the replacement fuse must match the data on the defective fuse.”

Fuse
21
Fuse box
Load compartment
Location
The fuse box is on the left side of the load compartment behind a cover.

Where is the fuse box?

Load compartment fuse box

The fuse box is on the left side of the load compartment behind a cover.

  1. 3-door hatchback, 5-door
  2. hatchback: Remove the cover.
  3. Sports tourer: Fold down the blind and remove.
  4. Sports tourer: Remove the cover.
  5. Sports tourer: When assembling press the blind into the rubber grommets to reach full retention force.
Load compartmentCarFixData schematic
Load compartment fuse box: map of 32 fuse positions, fuse 21 highlighted1234567891011121314151617181920222324252627282930313221
This fuseOther fuse positionsNot usedOur own schematic, drawn from the fuse positions printed in Vauxhall’s handbook illustration of this fuse box. Not to scale and not a manufacturer drawing — always match the number on the fuse box before pulling a fuse.

Where to look

  • 21

    The fuse box is on the left side of the load compartment behind a cover.

    Fuse · Heated front seats

    Highlighted on the load compartment map.

The map shows where each fuse sits. Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • One seat or both?

    If only one seat has failed, its own fuse, switch or heating pad is the likely cause.

  • Connector under the seat

    The seat wiring plugs in under the seat. Sliding the seat can strain or loosen this connector.

  • Heating element

    Elements can break inside the cushion, often where you kneel or slide in and out of the car.

Sources & verification

Applies toHandbook edition July 2013

Status
Verified
Specification
UK market
Last checked
15 October 2026

Applies toHandbook edition January 2014

Status
Verified
Specification
UK market
Last checked
15 October 2026

Applies toHandbook edition August 2014

Status
Verified
Specification
UK market
Last checked
15 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.