Find a fuse

Ford Fiesta · 2010

2010 Ford Fiesta Washer Pump Fuse

No screenwash when you pull the stalk? Check the washer pump fuse.

  • UK specification
  • Verified data
  • Checked 14 October 2026
  • Sources
Which 2010 Fiesta do you have?

The washer pump fuse differs between versions of the 2010 Ford Fiesta. Until you choose, every possible result is shown.

Not sure of your build date?
  • Many cars carry a manufacturer’s label (often called the VIN plate) that can show the build or production date. It is commonly on a door pillar, under the bonnet or at the base of the windscreen, but the exact place varies.
  • Your owner’s handbook, service record or original sales paperwork may show the build date or specification.
  • The first registration date on your V5C logbook is not the build date. Cars are often built weeks or months before they are registered, so it is only a rough guide near a changeover.
  • A franchised dealer can usually confirm the build date and specification from your VIN.
  • Still unsure? Compare the legend on your fuse box cover with each option.

If you can’t confirm it, keep both results in mind and check the fuse box legend before removing anything.

Quick answer

Verified

Option A Built 1 August 2009 to 28 February 2010

  • UK specification
  • Verified data
  • Checked 14 October 2026
  • Sources
Fuse
7
Amperage
10A
Fuse box
Passenger compartment
Location
Behind the glove box

Quick answer

Verified

Option B Built 1 March 2010 to 20 June 2010 or Built 21 June 2010 to 6 February 2011

  • UK specification
  • Verified data
  • Checked 14 October 2026
  • Sources
Fuse
7
Amperage
15A
Fuse box
Passenger compartment
Location
Behind the glove box

Where is the fuse box?

Option A Built 1 August 2009 to 28 February 2010

Passenger compartment fuse box

Behind the glove box

  1. Open the glove box and empty it.
  2. Press the sides of the glove box inwards and lower the glove box to reach the fuse box.

Option B Built 1 March 2010 to 20 June 2010 or Built 21 June 2010 to 6 February 2011

Passenger compartment fuse box

Behind the glove box

  1. Open the glove box and empty it.
  2. Press the sides of the glove box inwards and lower the glove box to reach the fuse box.

Fuse box diagram

Full 2010 Ford Fiesta fuse chart

Option A Built 1 August 2009 to 28 February 2010

We haven’t drawn a schematic of the passenger compartment fuse box for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.

Where to look

  • 7

    Behind the glove box

    Fuse ·10A · Washer pump

    Position not shown on the schematic. Find fuse 7 on the fuse box legend.

Always confirm the number against the legend on the fuse box cover before pulling anything.

Option B Built 1 March 2010 to 20 June 2010 or Built 21 June 2010 to 6 February 2011

We haven’t drawn a schematic of the passenger compartment fuse box for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.

Where to look

  • 7

    Behind the glove box

    Fuse ·15A · Washer pump

    Position not shown on the schematic. Find fuse 7 on the fuse box legend.

Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • Washer fluid level

    An empty reservoir is the most common cause. Top up with screenwash rather than plain water, especially in winter.

  • Frozen fluid

    Water or weak screenwash can freeze in the pipes and pump. Let the car warm up before trying again.

  • Listen for the pump

    If the pump hums but no fluid comes out, look for a blocked jet or a split or disconnected pipe.

Sources & verification

Type 1 passenger fuse box · Built 1 August 2009 to 28 February 2010

Status
Verified
Specification
UK market
Last checked
14 October 2026

Type 2 passenger fuse box · Built 1 August 2009 to 28 February 2010

Status
Verified
Specification
UK market
Last checked
14 October 2026

Type 1 passenger fuse box · Built 1 March 2010 to 20 June 2010

Status
Verified
Specification
UK market
Last checked
14 October 2026

Type 1 passenger fuse box · Built 21 June 2010 to 6 February 2011

Status
Verified
Specification
UK market
Last checked
14 October 2026

Type 2 passenger fuse box · Built 1 March 2010 to 20 June 2010

Status
Verified
Specification
UK market
Last checked
14 October 2026

Type 2 passenger fuse box · Built 21 June 2010 to 6 February 2011

Status
Verified
Specification
UK market
Last checked
14 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.