Quick answer

Verified

Applies toType 1 passenger fuse box · Built up to 4 January 2009Type 2 passenger fuse box · Built up to 4 January 2009

Fuel pump relay, diesel fuel heater

Fuse
34
Amperage
20A
Fuse box
Engine compartment
Location
In the engine compartment

PCM, gear selector lever, fuel pump

Fuse
14
Amperage
7.5A
Fuse box
Passenger compartment
Location
Behind the glove box

Fuel pump, fuel heater

Relay
R11
Fuse box
Engine compartment
Location
In the engine compartment

Where is the fuse box?

Engine compartment fuse box

In the engine compartment

Our source doesn’t describe how to open this fuse box. Check your owner’s handbook.

Passenger compartment fuse box (Type 1)

Behind the glove box

  1. Open the glove box and empty it.
  2. Press the sides of the glove box inwards and lower the glove box to reach the fuse box.

We haven’t drawn a schematic of the engine compartment fuse box for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.

We haven’t drawn a schematic of the passenger compartment fuse box (type 1) for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.

Where to look

  • 34

    In the engine compartment

    Fuse ·20A · Fuel pump relay, diesel fuel heater

    Position not shown on the schematic. Find fuse 34 on the fuse box legend.

  • 14

    Behind the glove box

    Fuse ·7.5A · PCM, gear selector lever, fuel pump

    Position not shown on the schematic. Find fuse 14 on the fuse box legend.

  • R11

    In the engine compartment

    Relay · Fuel pump, fuel heater

    Position not shown on the schematic. Find relay R11 on the fuse box legend.

Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Checking the relay

  1. With the ignition off, pull the relay straight out of its socket. Rock it gently if it is tight.
  2. Relays rarely look damaged when they fail. To test, swap in an identical relay with the same part number from a non-essential circuit.
  3. If the fault moves to the other circuit, replace the relay. If it doesn’t, the problem is elsewhere.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • Fuel cut-off switch

    Many cars cut the fuel pump after a jolt or impact. Your handbook will show if there is a reset switch.

  • Listen for the pump

    Turn the ignition on and listen for a short hum from under the rear seat. Silence suggests a power or pump fault.

  • Fuel level

    A faulty fuel gauge can hide an empty tank. Add a few litres before going further.

  • Fault codes

    An OBD scanner can show stored codes for fuel pressure or pump circuit faults.

Sources & verification

Applies toType 1 passenger fuse box · Built up to 4 January 2009

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toType 2 passenger fuse box · Built up to 4 January 2009

Status
Verified
Specification
UK market
Last checked
14 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.