Find a fuse

Vauxhall Mokka · 2022

2022 Vauxhall Mokka Heated Seat Fuse

Heated seats not warming up? Find the fuses Vauxhall lists for seat heating / the heated front seats.

  • UK specification
  • Verified data
  • Checked 15 October 2026
  • Sources

Quick answer

Verified

Applies toMokka · Handbook edition September 2021Mokka electric · Handbook edition September 2021

Vauxhall’s handbook doesn’t print fuse ratings, so none is shown. Fit a replacement with the same rating as the fuse you remove — the handbook says: “Data on the replacement fuse must match the data on the defective fuse.”

Fuse
10
Fuse box
Instrument panel, right side
Location
In right-hand drive vehicles, the fuse box is located behind a cover in the instrument panel.

Where is the fuse box?

Instrument panel fuse box (right side)

In right-hand drive vehicles, the fuse box is located behind a cover in the instrument panel.

  1. Disengage cover at the bottom side and remove.
  2. Remove the bracket.

Fuse box diagram

Full 2022 Vauxhall Mokka fuse chart
Instrument panel, right sideCarFixData schematic
Instrument panel fuse box (right side): map of 12 fuse positions, fuse 10 highlighted123456789111210
This fuseOther fuse positionsNot listed in this chartOur own schematic, drawn from the fuse positions printed in Vauxhall’s handbook illustration of this fuse box. Not to scale and not a manufacturer drawing — always match the number on the fuse box before pulling a fuse.

Where to look

  • 10

    In right-hand drive vehicles, the fuse box is located behind a cover in the instrument panel.

    Fuse · Heated front seats

    Highlighted on the instrument panel, right side map.

The map shows where each fuse sits. Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • One seat or both?

    If only one seat has failed, its own fuse, switch or heating pad is the likely cause.

  • Connector under the seat

    The seat wiring plugs in under the seat. Sliding the seat can strain or loosen this connector.

  • Heating element

    Elements can break inside the cushion, often where you kneel or slide in and out of the car.

Sources & verification

Applies toMokka · Handbook edition September 2021

Status
Verified
Specification
UK market
Last checked
15 October 2026

Applies toMokka electric · Handbook edition September 2021

Status
Verified
Specification
UK market
Last checked
15 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.