Ford Focus · 2025
2025 Ford Focus Wiper Fuse
Wipers stopped working? Find the fuses for the front wipers, rear wiper and automatic wipers.
- UK specification
- Verified data
- Checked 14 October 2026
- Sources
Quick answer
VerifiedWindshield wipers.
- Fuse
- 69
- Amperage
- 30A
- Fuse box
- Under the bonnet
- Location
- Under the bonnet (engine compartment)
Rear window wiper.
- Fuse
- 71
- Amperage
- 20A
- Fuse box
- Under the bonnet
- Location
- Under the bonnet (engine compartment)
Where is the fuse box?
Under hood fuse box
Under the bonnet (engine compartment)
- Pull the latch toward you and remove the top cover.
- Pull the connector lever upward.
- Pull the connector upward to remove it.
- Pull both latches toward you and remove the fuse box.
- Turn the fuse box over and open the lid.
Fuse box diagram
Full 2025 Ford Focus fuse chartWe haven’t drawn a schematic of the under hood fuse box for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.
Where to look
- 69
Under the bonnet (engine compartment)
Fuse ·30A · Windshield wipers.
Position not shown on the schematic. Find fuse 69 on the fuse box legend.
- 71
Under the bonnet (engine compartment)
Fuse ·20A · Rear window wiper.
Position not shown on the schematic. Find fuse 71 on the fuse box legend.
Always confirm the number against the legend on the fuse box cover before pulling anything.
How to replace the fuse safely
- Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
- Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
- Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
- Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
- Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
- Refit the cover, switch on and test the component.
- Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
- Never bridge a fuse with wire, foil or anything else.
Fuse keeps blowing?
A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.
Not the fuse? Check these next.
Frozen or stuck blades
Blades frozen to the glass, or snow packed below the windscreen, can stall the motor and blow the fuse. Free them before switching on.
Loose wiper arm
If you can hear the motor running but an arm doesn’t move, the nut holding the arm or the linkage may have come loose.
Wiper stalk
If some speeds work and others don’t, the stalk switch is more likely than the fuse.
Sources & verification
- Manufacturer manual listingFord UK — 2024 Focus (2018) owner manuals · Ford Motor Company · Owner’s Manual (Vehicles Built From: 21/03/2024) · Accessed 14 October 2026
- Manufacturer manual listingFord UK — 2025 Focus (2018) owner manuals · Ford Motor Company · Owner’s Manual (Vehicles Built From: 21/03/2024) · Accessed 14 October 2026
- Owner’s manualFord Focus (2018) Owner’s Manual — CG3929en-202309-20231024095529.pdf, edition 09/2023 · Ford Motor Company · Fuse specification chart — Under hood fuse box (pp. 341–343); Fuse specification chart — Passenger compartment fuse box (pp. 345–346); Fuse specification chart — Trailer tow module fuse box (5-door and wagon) (pp. 346–346) · Accessed 14 October 2026
Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.