Find a fuse

Ford Fiesta · 2013

2013 Ford Fiesta Washer Pump Fuse

No screenwash when you pull the stalk? Check the washer pump fuse.

  • UK specification
  • Verified data
  • Checked 13 October 2026
  • Sources

Quick answer

Verified

Applies toFiesta (2008) · Type 1 passenger fuse box · Built from 27 February 2012Fiesta (2008) · Type 2 passenger fuse box · Built from 27 February 2012Fiesta (2012) · Built up to 6 January 2013Fiesta (2012) · Built 7 January 2013 to 20 March 2014

Fuse
7
Amperage
15A
Fuse box
Passenger compartment
Location
Behind the glove box

Where is the fuse box?

Passenger compartment fuse box (Type 1)

Behind the glove box

  1. Open the glove box and empty it.
  2. Press the sides of the glove box inwards and lower the glove box to reach the fuse box.

Fuse box diagram

Full 2013 Ford Fiesta fuse chart

We haven’t drawn a schematic of the passenger compartment fuse box (type 1) for this version yet. Use the fuse and relay numbers on this page and the legend on the fuse box to find the right position.

Where to look

  • 7

    Behind the glove box

    Fuse ·15A · Washer pump

    Position not shown on the schematic. Find fuse 7 on the fuse box legend.

Always confirm the number against the legend on the fuse box cover before pulling anything.

How to replace the fuse safely

  1. Switch off the ignition and all electrical equipment. Take the key out, or move a keyless fob away from the car.
  2. Open the fuse box and find the fuse using the number on the cover legend or the chart on this page.
  3. Pull the fuse straight out with the plastic fuse puller (usually clipped inside the fuse box) or fine-nose pliers.
  4. Look at the metal strip inside the fuse. A broken or burnt strip means it has blown.
  5. Fit a new fuse with exactly the same amperage rating. The number on top and the colour should match.
  6. Refit the cover, switch on and test the component.
  • Never fit a fuse with a higher amperage rating than specified. It can let wiring overheat.
  • Never bridge a fuse with wire, foil or anything else.

Fuse keeps blowing?

A fuse that blows again straight away is doing its job. Something on that circuit is drawing too much current. Common causes are damaged wiring shorting to the bodywork, a failing motor or socket, water getting in, or a faulty accessory. Fitting fuse after fuse, or a bigger fuse, won’t fix the fault and can overheat the wiring. Have the circuit tested by an auto electrician.

Not the fuse? Check these next.

  • Washer fluid level

    An empty reservoir is the most common cause. Top up with screenwash rather than plain water, especially in winter.

  • Frozen fluid

    Water or weak screenwash can freeze in the pipes and pump. Let the car warm up before trying again.

  • Listen for the pump

    If the pump hums but no fluid comes out, look for a blocked jet or a split or disconnected pipe.

Sources & verification

Applies toFiesta (2008) · Type 1 passenger fuse box · Built from 27 February 2012

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toFiesta (2008) · Type 2 passenger fuse box · Built from 27 February 2012

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toFiesta (2012) · Built up to 6 January 2013

Status
Verified
Specification
UK market
Last checked
14 October 2026

Applies toFiesta (2012) · Built 7 January 2013 to 20 March 2014

Status
Verified
Specification
UK market
Last checked
13 October 2026

Fuse layouts can differ between trim levels and optional equipment. Always confirm against the legend on your fuse box.